DuraVision FDV1001T User Manual download pdf (Page 16)

Chapter 2 Connecting Cables

2-3.Installing the Touch Panel Driver

ATTENTION

• The user account to be used for installing the touch panel driver must have the “Administrators” privilege.

• When reinstalling the touch panel driver to update the driver, etc., restart the PC after uninstalling the driver and

then install it.

Uninstall the other touch panel driver, if it is installed.

Install the touch panel driver according to the instructions included in the CD-

ROM.

For how to install the touch panel driver, see the Touch Panel Driver User’s Manual (on the CD-ROM).

Connect the monitor to the PC with the included RS-232C signal cable.

Connectors on the PC

COM port

Connectors on the

monitor

Serial port for the

touch panel

RS-232C Cable (supplied)

Restart the PC.

ATTENTION

• After the restart, set up the device using the following procedure. For details, refer to the Touch Panel Driver User’s

Manual (on the CD-ROM).

1. Click “Start” - “All Program” - “DMC” - “DMC Touch Panel Conguration” to display the [Properties] window.

2. Click “Add a serial device”, and register a new serial device.

3. Click “Device”, and specify the COM port number used for [COM port].

4. Click “Apply”.

5. Click “Close”.

2-4.Calibrating the Monitor

Calibrate the monitor according to the instruction manual for the touch panel driver on the CD-ROM.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 33 34

No comments

DuraVision FDV1001T User Manual Page 16